Hi,
I wouldn't encourage you to go in that direction unless the preamp had very low output impedance -- 100 ohms or less in the RCA mode -- AND the interconnect between the two components was very short -- two meters or less. Trying to run a solid-state amp from a toooob pre will generally give you an overly smooooth sound with limited dynamics, roll-off of both frequency extremes and shrinking soundstage -- that is if you're on the "not recommended" side of the above guidelines.
Best of luck,
Joe
I wouldn't encourage you to go in that direction unless the preamp had very low output impedance -- 100 ohms or less in the RCA mode -- AND the interconnect between the two components was very short -- two meters or less. Trying to run a solid-state amp from a toooob pre will generally give you an overly smooooth sound with limited dynamics, roll-off of both frequency extremes and shrinking soundstage -- that is if you're on the "not recommended" side of the above guidelines.
Best of luck,
Joe