TOTEM Sttaf removing mass loading

Yeah, beaks and mass loading are kind of the same . . .

Be sure to impress on the seller that the removal of ALL the mass loading material before shipping is important.

A 25% full compartment is worse than a 100% full one. Think of the pile driver effect as the fill material moves around. They'll also cost less to ship if completely empty.

Is the load compartment completely isolated from the rest of the cabinet on the sttaf?

If so, I don't see any issue with unloading at all, the issue becomes quite trivial actually.

Is the load compartment completely isolated from the rest of the cabinet on the sttaf?

yes, it's a separate chamber at the base of the speaker. It's purpose built for loading, and you're right - it's a trivial concern.

A few specs of residual kitty litter doesn’t weigh much, I would not worry about it. As long as there sealed up appropriately.

"totem also recommended ’beaks’...yeah, right."

The beaks can make a dramatic difference. I hung around while a friend tuned his sttaf’s long after they endured plenty of break in time. Then beaks were installed. Unlike a lot of flashy gimmicks they are one of those things that just work. After beaks were installed they were partially loaded with Sudbury nickel.

dfelkai I recommend trying both, beaks and mass. Run them bare until you get accustomed to them, then do a before and after. Don’t fill them up at one go. Gradually load, test, repeat. When you pass an obvious sweet spot remove a little. Weighing each time you add makes it easy.