Too Much Power


Please bear with me as I am nowhere near an expert at this type of thing...

I recently read a review of the PS Audio Stellar M1200 mono amps. I was somewhat taken aback by their power rating of  600 watts at 8 ohms/1200 watts at 4 ohms. Made me wonder what, if any, are the drawbacks to that much power? Welcome your thoughts...

gnoworyta

with speakers rated at 900 watts and have little concern about over powering or damaging them

You have a home audio speaker that can take 900 watts?

I bought these to replace a Peachtree 220. They are light weight, dead quiet and sound great. I got an offer from PS Audio to trade them for a BHK Stereo 250 so I accepted and shipped the monoblocks back. The 250 is a lot noisier but is creamy and wonderful.  Too much power is better than not enough, and you would have to turn up the volume almost all the way to get close to the maximum output. The 250 watts is more than I need because my speakers have powered subwoofers and the input impedance is over 20 ohms at low frequencies. 

@russ69 I know 900 watts sounds like a stretch and I can neither confirm or deny, though that is what's listed on the product literature

 

  • Made under U.S. Patent 9247339 with multiple new patents pending
  • Ultra-linear frequency response
  • Proprietary patent pending 15 dome radiating hybrid MTM high-frequency array
  • Dual 12″ low-frequency transducers
  • 98dB 2.83V@1m sensitivity
  • 4 or 8 Ohm design – we suggest 4 Ohm for optimum performance
  • 20Hz-30kHz frequency response
  • Height 69.0″ (175.26 cm) x Width 13.5″ (34.29 cm) x Depth 17.0″ (43.18 cm)
  • 900 Watt power handling
  • Weight 135 lbs
  • Manufactured in the USA

@stevewharton  Wow. I had not seen that before. That is quite a claim. Not sure I'd want to test that claim. Thanx for the reply.