What the other posters have not mentioned is that also if your arm is the TP-16 Mk 1 version at 16.5gms effective mass,you probably have a mismatch using a Grado Silver on that arm.The Grado weighs 5.5 gms and the compliance is high at 20cus.This would result in a tonearm,cartridge resonance of about 7.4Hz which is actually quite low i.e too near the resonance of the table.You would want to be around 11-12Hz optimally.You can get a lot of info with a seach here on this site about addressing this issue.A cartridge with a lower compliance than a Grado would be a way to go.
Thorens TP-16 Tonearm cartridge mounting issue
Recently, I have acquired a Thorens TD-160 MKI equipped with the original TP-16 tonearm and headshell. I am using Dynavector 10x5 and Grado Gold cartridges but would like to try a Reference Grado in the near future. The problem lies within the headshell of the TP-16 tonearm, as it only allows for mounting from underneath the headshell and there are no holes on the top. After close examination, it seems I can remove the lid of the headshell but there remains a top that lies just above the threaded cartridge plate. Ideally, I would like to have 2 slots located above the headshell plate for cartridge installation and adjustment, this would make installation for Grado Reference and other cartridges much easier.
Does anyone know if there are other headshells that I could fit directly on the end of a TP16 with open slots on the top? Maybe a MKII headshell would work but I am really not sure?
Here is a link to a picture of a TP16 tonearm-
http://www.vinylengine.com/library/thorens/tp16.shtml
Thanks to everyone for your input.
Cheers,
Chris
Does anyone know if there are other headshells that I could fit directly on the end of a TP16 with open slots on the top? Maybe a MKII headshell would work but I am really not sure?
Here is a link to a picture of a TP16 tonearm-
http://www.vinylengine.com/library/thorens/tp16.shtml
Thanks to everyone for your input.
Cheers,
Chris