Stillpoints ERS cloth for EMI/RFI

I bought two sheets.
It works for me.
I plan to buy more.

I taped cut pieces around the transformers in the power supply of my Steelhead,on top of some caps,and around the power IEC.
I also wrapped another smaller linear power supply to my LTS volume control.
I put some on top of my Furman IT 1500 balanced power unit(over transformer but outside unit),and a small piece under one of my Furutech GTX D reptacles which sits out from the wall on a DIY platform on the floor which powers up the Furman and my two Acoustat servo amps.

There are a few places I would like to try the cloth,inside the Furman,which I will do when I order some more.

I also did some DIY shielding to the open wires inside both of the Steelhead chassis.I taped some pads under the metal chassis where the transformers are ,this time on the outside.

The end result is my vinyl sounds more focused.Instruments and vocals are easier to make out.
There's better differentiation.

I wrapped the transformer in my Furman balanced power conditioner because I noticed that this is what BPT does to the transformer in their units.

It made an improvement in my Furman, so I bought more sheets and wrapped every transformer I could throughout my system.

I don't know if it is shielding incoming EMI/RFI or outgoing from the gear.

All I know is that I like the results.

If I ever come across mu-metal and it's as cheap as the ERS, I'll certainly give that a try.

Something tells me that cutting and fitting cloth is easier than cutting and fitting metal.

I use electrical tape to affix the cloth.

What would you use to attach mu metal to a transformer?

Thanks Geoffkait,the search is on for mu metal.

Found it ,same price as ERS.
Time to place an order for a few sheets.