I did what Theo recommends...ran a length of lamp cord from ground connection on back of surge protector to side of wood equipment table. Just touch the bare wire end before touching the equipment.
There was an old post on A'gon a while back where the ground wire was connected to a brass door knob mounted on a small wood panel. Dressed things up a bit. The writer included instructions on putting a resistor in the circuit, as I recall. This reduced/eliminated the "pain" of the shock when you grounded yourself to the knob.
There was an old post on A'gon a while back where the ground wire was connected to a brass door knob mounted on a small wood panel. Dressed things up a bit. The writer included instructions on putting a resistor in the circuit, as I recall. This reduced/eliminated the "pain" of the shock when you grounded yourself to the knob.