We use the tape outs to tie systems together lots of times. It works well. In addition all other sources will be sent to the other receiver also.
Splitting turntable signal
Hi, here's what I am trying to achieve, please let me know if this is feasible at all.
I have a Rotel RP900 and Rega arm turntable, which goes into a Parasound P-100 amplifier. After this amplifier I would like to split the signal so that it goes to two different amplifiers in separate rooms:
(1) can this be done and what kind of splitter would I need? Assuming that I would not need both systems to be on at the same time, should I look into a switch rather than a splitter?
(2) what are the maximum recommended lengths after the amplifier (assuming this split which should be roughly...-3 dB?) that I could run?
Thanks a lot for all the help!
I have a Rotel RP900 and Rega arm turntable, which goes into a Parasound P-100 amplifier. After this amplifier I would like to split the signal so that it goes to two different amplifiers in separate rooms:
(1) can this be done and what kind of splitter would I need? Assuming that I would not need both systems to be on at the same time, should I look into a switch rather than a splitter?
(2) what are the maximum recommended lengths after the amplifier (assuming this split which should be roughly...-3 dB?) that I could run?
Thanks a lot for all the help!
- ...
- 7 posts total
- 7 posts total