You also need to keep in mind that in most cases using both preamp’s outputs at the same time running two separate but identical amps, will present half of one of the amp’s input impedance to the preamp. Depending on the preamp output impedance and the amp input impedance, e.g., ratio of 1 to 10, etc., the results may impact the ultimate sound quality.
Splitter -- One preamp to two amps. What to use?
I need your help! If people are bi-amping, How are they connecting from their preamp to their two amps and to their speakers?
I am currently running my NAD 1700 preamp with two separate outputs. One is a Lab unfiltered RCA out which goes to my Mid’s and Highs into one of my NAD 2600 amps. And I have a second RCA Normal, which is lower fidelity which runs thru another NAD 2600 into my woofers. I then run two sets of 10 gauge Blue Jean cable to each speaker. What I would like to do us upgrade my speaker wire ( AudioQuest Redwood or DR Acoustics Red Sky Bi wire ) which are bi-wire cables and bridge my amps to achieve 450 watts per channel.
Here is the problem. In order to do this I need to split the one output from the Lab RCA on my preamp to feed the two separate amps. I am currently using Audioquest Waters and hate to put something inline that is a lower quality than the Waters.
I can’t believe I am the only one with this problem. How are the smart audiophiles addressing this problem?
I am currently running my NAD 1700 preamp with two separate outputs. One is a Lab unfiltered RCA out which goes to my Mid’s and Highs into one of my NAD 2600 amps. And I have a second RCA Normal, which is lower fidelity which runs thru another NAD 2600 into my woofers. I then run two sets of 10 gauge Blue Jean cable to each speaker. What I would like to do us upgrade my speaker wire ( AudioQuest Redwood or DR Acoustics Red Sky Bi wire ) which are bi-wire cables and bridge my amps to achieve 450 watts per channel.
Here is the problem. In order to do this I need to split the one output from the Lab RCA on my preamp to feed the two separate amps. I am currently using Audioquest Waters and hate to put something inline that is a lower quality than the Waters.
I can’t believe I am the only one with this problem. How are the smart audiophiles addressing this problem?