I would try to absorb speaker vibrations into a maple platform. Think about this: If your speakers sit on top of a hard surface (like marble), then all vibrations that your speaker produces goes down the cabinet, through the spikes, and hit the marble. Then, reflects off of the marble, up through the spikes again, and back into the cabinet.
Spikes-Marble-Carpet-Wood Floors
My Snell CVs are about 100 lbs each. My hardwood floors are covered with a wool rug and pad. Currently I am using a set of aluminum Tiptoes I have had for about 20+ years.
The Tiptoes are not threaded they just sit under the speakers. I am not sure they are really coupled to the floor that well. They are going thru the rug and pad but is that enough?
I do have two marble slabs that could go under the speakers.
Should I place the marble under the rug? or on top of the rug? I am also wondering about gluing the Tiptoes to the bottoms of the speakers for a better connection.
Or should I just make some threaded DIY spikes and forget the Tiptoes?
The Tiptoes are not threaded they just sit under the speakers. I am not sure they are really coupled to the floor that well. They are going thru the rug and pad but is that enough?
I do have two marble slabs that could go under the speakers.
Should I place the marble under the rug? or on top of the rug? I am also wondering about gluing the Tiptoes to the bottoms of the speakers for a better connection.
Or should I just make some threaded DIY spikes and forget the Tiptoes?