2. speakers
  3. 167586-162856

speakers for classic receiver

Hello, I need some help matching speakers with two Sansui receivers: the 881 and the g 9000. Would the Focal Aria 936, flr standing speakers be too much stress on those receivers? I was informed that 8ohm would be best. However,  since i'm  not familiar with the technical aspects of speakers , sensitivity and ohms< I  need  assistance. The Aria specs  state they have a nominal impedance of 8ohm but a minimum low of 2.8ohm. That min. low impedance is confusing. In short, are these speakers a good match?I dont play music loudly at all and not for long periods. My room size is approx. 15 x14 x8. Both Sansui models were fully serviced ( recapped, aligned, cleaned). Thanks for any help and information.
trent77

Showing 1 response by hshifi

hshifi
572 posts
 
Hello,
It sounds like it will push the Focal’s just fine. Typically older stuff had two sets of speaker posts. Even if the Focal’s dip down to 4 ohms you will be fine. I would not bi-amp off the Sansui. Stick with one set of speaker posts and use jumpers on the speakers if you need them. Due to the deal your getting its worth it. Later you can upgrade the amp to get better headroom and sound stage. You might be able to add an amp to the Sansui and then add a better preamp like a Rogue tube preamp with a SS amp. Go for it. Speakers make a huge difference in your system. 
More to discover