speaker wiring for h/t and stereo


What options are available if I aim to have a speaker set up with a valve amp and cd for stereo and also use the same speakers through a/v receiver in h/t set up not wishing to compromise the stereo sound?
valverocks

Showing 2 responses by blindjim


Macdadtexas

"simpler to just have a preamp with HT passthrough, most of the good ones have it."

Perhaps many of the newer preamps have the HT pass thru feature... new however doesn't equate to good though... nor does having more features such as 'pass thru'.... unless of course Good = bells and whistles.

Short of rushing out to by another preamp as Macdadtexas suggested, you can simply swap the speaker leads between the two rigs when desired... although an obvious pain perhaps, short of getting another pre, and another set of cables as well for the bypass, that works for me...

Of course, adding another set of speaker cables from the HT rec. to the speakers will do it too... You have to be mindful each power source has to be off prior to switching them though.

Separating the two systems seems the best choice so they can run 100% independant of one another.

It's looking more and more like that's what I'm going to be doing pretty soon myself. I'm considering however to use some wall mounted speakers though for mains in the HT... and I'd still be able to use the same dedicated room for both 2 ch & HT.
I thought I mentioned making connections whilst everything was dead...? Anyhow.. Absolutely DO not energize amps without a load being connected to them.

I did the line out and line in bit too... and wound up with a fairly significant lag in the audio stream coming from the speakers my tube power train were driving when hooked to the HT system. I then hooked the Receiver straight to the tube monos for the front mains and the SS amp for the rears... and as was said, got a little hinkey about burning up my tubes for movies and TV, and went back to just using the Odyssey Se for them fronts and doing the speaker cable shuffle... Weekends when I expect company, the HT is all connected. Tuesdays to Fridays, usually, the tubes run the show... musical show, that is... no vids.

I didn't see where I could delay or advance the audio anywhere in the setup menu to compensate for the timing differences I was experiencing with my Onkyo 805... only in the center ch could I affect any changes.. ie., lip sync.

it wasn't off by much. Just enough to agrivate me though.