Speaker Cable for Interconnect


I have some left over short runs of Kimber 4TC and Nordost Flatline speaker cables that I would like to make IC out of them. Jon Risch DIY recommend Belden 89259 coax for both DIY speaker and IC so I figure why can't I use what I have. Any suggestion or consideration on sound quality and what to watch out for before I start?

Spud.
spudspot

Showing 1 response by sean

I think that the PBJ's use double grounds and one hot. From what i can recall, the grounds are connected at both ends, so there is no "drain wire" in this design. I have some on my burner, so i'll take a look tomorrow and correct this if it's wrong. Sean
>