Here is a link to a good primer on cable design, and what is going on electrically. It's on a cable manufacture's website, but it is not pseudo science.
http://www.absolutefidelity.com/thedesign.html
http://www.absolutefidelity.com/thedesign.html
Something doesn't seem right about this...
When a speaker cable is designed with the positive lead(s)
intertwined with the negative (I'd name names but almost everyone does it),
won't this cancel out some signal?
When an amplified audio signal pulses down the + wire (to your speaker)
it does some work (i.e. makes some sound) then exits in the - (minus)
wire to ground and completes the circuit.
If these wires are next to each other, the incoming signal (+) will be affected by the outgoing (-) won't it?
What am I missing?
intertwined with the negative (I'd name names but almost everyone does it),
won't this cancel out some signal?
When an amplified audio signal pulses down the + wire (to your speaker)
it does some work (i.e. makes some sound) then exits in the - (minus)
wire to ground and completes the circuit.
If these wires are next to each other, the incoming signal (+) will be affected by the outgoing (-) won't it?
What am I missing?