Snell E/III vs. Snell Type D loudspeakers

I have recently aquired a mint pair of CV. They obviously were rarely if ever played. At first the bass was incredibly boomy and ill defined. Now the bass is somewhat shy in my room after 'breakin'. I have done the following. The tweeter level control and fuse have been bi-passed. To bring up the bass level. The rear port has been reduced in diameter and the empty space at the bottom filled with poly/fiberglass wool. I also removed that stick on foam from the front. Have treated the mid/tweet with my own method of tuning with weather strip foam. The CV is exremely low in coloration, plays loud/dynamic and clear, has a very open soudstage. The midbass and lower mids i do find to be a bit recessed. I am using ss amp-tube pre combo. All my tweaks are completely reversible to preserve resale value. I think you could spend 8k retail today and have no better a speaker than the CV.

Both the fuse and level control were bypassed. Not satisfied with this MUCH more natural and transparent sound. I played around with the power resistor pad glued to the back of the crossover plate. They use a 4ohm followed by a 2ohm at the x-over input. I settled on replacing the 4ohm with around 3.5ohm. Kicks up the tweeter about 1/2 db or so. Also the input wires terminate at 1 set of binding posts now. I absolutely hate the MUDDY sound of bi-wired speakers. This way no jumper is needed. I also have the speaker up off the floor about 2 1/2 inches. Right now I actually removed the added stuffing . Instead, I added a small foam strip to the woofer dust cover cone centers. This makes the cone play a bit lower and more defined. May add back some fill if needed. Also, they use fiberglass in the midrange enclosures. Polyfill gives a more open detailed sound, so that was changed too. If I had a 20,000 speaker in my room, it would be subject to the same tweaking. The hobby is all about getting the speaker to work for you.

Both the fuse and level control were bypassed. Not satisfied with this MUCH more natural and transparent sound. I played around with the power resistor pad glued to the back of the crossover plate. They use a 4ohm followed by a 2ohm at the x-over input. I settled on replacing the 4ohm with around 3.5ohm. Kicks up the tweeter about 1/2 db or so. Also the input wires terminate at 1 set of binding posts now. I absolutely hate the MUDDY sound of bi-wired speakers. This way no jumper is needed. I also have the speaker up off the floor about 2 1/2 inches. Right now I actually removed the added stuffing . Instead, I added a small foam strip to the woofer dust cover cone centers. This makes the cone play a bit lower and more defined. May add back some fill if needed. Also, they use fiberglass in the midrange enclosures. Polyfill gives a more open detailed sound, so that was changed too. If I had a 20,000 speaker in my room, it would be subject to the same tweaking. The hobby is all about getting the speaker to work for you.