I have a pair of 840W (powered through an Audience aR2p-TO connected to a single dedicated outlet) and have no problem driving Wilson Sophias (4 ohm) in unbridged dual mono mode. When I try to run the amps in bridged mono mode, everything starts out ok, but a midrange buzz develops and increases in volume after about 10 minutes. If I switch either amp into standby, the buzz goes away, and the remaining channel sounds fine. Is this a ground loop problem? Will placing a ground between the two amps solve the problem? Any other suggestions?
single Cambridge audio azur 840w vs bridged mono
Hi,
i have the azur 840w in stereo mode, i like the way he sound but i would like to have much more detail and focus.
I dont know if i need the extra power but i want better sound quality.
My speaker is dynaudio contour s5.4.
What can i get if i buy another 840w for a bridged mono application(no bi wiring on the speakers).
thank you
i have the azur 840w in stereo mode, i like the way he sound but i would like to have much more detail and focus.
I dont know if i need the extra power but i want better sound quality.
My speaker is dynaudio contour s5.4.
What can i get if i buy another 840w for a bridged mono application(no bi wiring on the speakers).
thank you