2. analog
  3. 1364781525

Simple & Cheap Way to Cut Turntable Vibrations

This OP is dedicated to Elizabeth, A'gon's paragon of audio economics and sensibility.

I accidentally discovered a way to substantially reduce bass and vibration feedback into my VPI Classic turntable. Oh, I have to thank my wife too. Last week my wife asked me to place padded furniture stickies under the feet of our bed to protect the hardwood floor.

I looked as these cheap gizmos and said to myself, I have a better idea. I place a padded sticky under each foot of my TT. I was amazed by how much it really reduced feedback. I even knocked on the el cheapo IKEA table on which I placed the TT -- no feedback. Trust me, the IKEA table is the worst place to put any audio equipment, especially a TT.

Try it folks and let the rest of us know what you think.
bifwynne

Showing 1 response by ptmconsulting

ptmconsulting
1,000 posts
 
Yup squash balls under my VPI too. However I did it a little differently. Put the TT on a maple butcher block cutting board, then put about 9 squash balls between that board and the table top, making a cheap man's Ginko Cloud. You can rearrange the balls to put more under the heavier table spots, like the motor, to balance it out. Over time these compress much more than initially, so you should check your level from time to time and adjust.

This setup passes the knuckle wrap test (stylus in a groove, record not spinning, rap on the supporting table top/leg - no sound through the speaker).

Enjoy,
Bob
More to discover