sibilance in system


It has been a long while since I have posted here.  I have recently changed my system and am having a not huge issue with sibilance.

System is: Nottingham Spacedeck, SME 309 arm with cable upgrade (not silver), Zyx ultimate 100 cart, vacuum state JLTI phono stage, Cayin A300B SET *WPC integrated with tube upgrades (EML tall mesh 300 B, vintage tubes in other sockets), Omega Super 6 AlNiCo floor speakers.  Interconnects vary, mostly anticables and also Speltz Zeros in line with speakers, pair Omega deep hemp subs.  I only have about 25 hours on the Zyx (had an Airy 3 before, but that went away due to damage, don't ask) and only about 35 hours on the Omegas.  So maybe I should just wait a while?

It is not a huge problem, and varies with the recording.  Tube rolling helped a bit.  I am considering other cartridges or possibly other speakers. 

My listening preferences (what I like in music), wide deep "holographic sound stage.  inner detail and separation, good imaging and proper instrument timbre.  I don't care much about base slam, or what I think folks mean by "musicality".  I listen to a wide range of music, mostly 1960's 1970's rock, and folk; orchestral music; some world music and jazz thrown in.

Any ideas would be welcome, including ways to improve on the preferences listed above without spending more than what my car cost...

Thanks for the bandwidth.

 

oceanica

Showing 1 response by dekay

Play the setup (without changing anything) for another 100+ hours.

Never heard Omega's, bur have been using wide-band single driver speakers for 20+ years and even NOS from the 50's/60's need @ least 100/200 hours to sound like they WILL sound.

The drivers typically have an extremely low Xmax rating considering the frequency range they cover and it takes time/use to loosen up their stiff surrounds.

This seems to be the case with foam (Lowther et cetera) VS paper surrounds as well, which I don't understand, but it is what's reported.

All of my single drivers have folded paper surrounds which is the type that I believe Omega uses as well.

Mixing/changing things up during a new component break-in period just complicates achieving a solution to the issue(s) you are attempting to remedy.

 

DeKay