2. digital
  3. 1155607811

Shanling CDT-100 Technical difficulties

Recently, I posted a thread about my problems with my CDT-100 remote. I finally disconnected the whole unit and took it back to the place of purchase. Wouldn't you know it. Everything worked perfectly. Upon its return, it worked fine for about one day remote and all. Now the remote is not working and I get no output from either the tube or solid state outputs? This unit is pristine condtion and handled with kid gloves, just like everyone else on this site. I don't know what to do. I use an Audience PC into a PS audio strip. I have also tried turning the unit on and off to relieve static BU. no luck. When the remote was working I switched back and forth from upsampling to std redbook, that used to work. Now I can't use the remote. HELP!!
Ag insider logo xs@2xbrett11
6 responses Add your response
flye
39 posts
 
Dear Brett,

Is the disc spinning? If the disc is not spinning make sure the lid for the cd depresses the button on the chassis to activate. Always use the solid state output for test purposes as the tube stage is simply in series with it.
This could also be a problem with a relay at the upsampling
circuit. It seems like there is no data getting to the dac chip because both channels are out. This is usually a data/dac issue as the likelihood of both channels failing at once are remote. Good luck

Kyle Takenaga
Ag insider logo xs@2x
brett11 OP
27 posts
 
Kyle - the disc is spinning and everything seems to be operating as it should. Just no sound! Should I take it out of the system again and try it. I don't know.
flye
39 posts
 
Dear Brett,

Try flipping the upsampling button on and off repeatedly.
Maybe this will free it up. Do you here a clicking noise inside the unit? It really sound like something to do with the relay.

Best Regards,

Kyle Takenaga
Ag insider logo xs@2x
brett11 OP
27 posts
 
Kyle - The remote will not respond at all. This was the beginning of the problem, now nothing works. The player behaves as normal, BUT there is no sound output and no remote use. As I stated earlier, I pulled it out of the system and tried it in another. The remote worked as did the CD player, it also worked fine for a few hours when I got home and then the current problems began. I can't change the upsampling without the remote.
rubinken's avatar
rubinken
102 posts
 
Brett-
Why don't you call the Shanling Repair Guru:
Mitch Singerman
(310)823-5145

He's authorized, knowledgable & communicative. Good luck.
Ag insider logo xs@2x
brett11 OP
27 posts
 
Thank you very much for the recommendation of Mitch Singerman. He is top notch.
Log in to respond
More to discover
80x80
Weiss Engineering DAC501
80x80
RME ADI-2 DAC
80x80
MSB Technology The Select