2. analog
  3. 1042680308

Setting VTA on a new Shelter 901?

I'm trying to dial in a new Shelter 901, knowing I face several dozen hours of break-in before I ought to be too critical.

It's in an SME IV.vi arm on a SOTA Star. The arm has a VTA adjustment dial/rod...but it's not that easy to move, up or downward. Both ways requires loosening some base screws, etc. Not precisely repeatable, either. Nevermind that, my question is...

What's a good "geometry" ballpark to begin VTA tweaking...
cartridge bottom parallel to record? Slightly down at the back? Somebody on Audiogon mentioned slightly down at the front, but that sounds (and looks, in my mind's eye) very scary. But, so far, what do I know?

The cartridge is very, very slightly down in the rear right now, about 1-2° I'd say. Bass seems mostly controlled, but load...treble (strings) are very bright...vocals I'm familiar with seem pretty about right...so far, nothing I'd call warmth. That's some break-up that happens on crescendos...sounds like eggs frying ...seems more like electronic distortion ugliness that mistracking.

Thanks for any help and ideas.

Noel
nnauber

Showing 2 responses by sbank

sbank's avatar
sbank
3,382 posts
 
Thanks for the insight, Twl. I'll get working on it.
The fun is just beginning! Spencer
sbank's avatar
sbank
3,382 posts
 
4yanx,
Your comments are revealing, as well. My 501/II has about 35 hours(Oscar P. & Ray Brown are working on hour 36 as we speak!), and I'm relishing every nugget of info in this thread. My Spacearm is set about flat for now, and I'm also going to wait until 100 hours before I tweak it much. With this arm, I haven't yet figured out the best way to adjust in an ideally methodical fashion.

Anybody finding phonostage impedance settings having affect on break-in and/or? I recall someone suggesting to go w/setting at 47k until about 100 hours, then switching down to the recommended 100 ohms. Mine's been at 100 ohms all along. Thoughts?
More to discover