If I have to be honest I discover sra just recently. Before the only thing I knew was that the arm should be parallel to the record; so, two years ago when I fitted the cart I didn't check for sra. But from what I recall the stylus and the cantilever angle never changed through time. The cantilever though always seems to me to ride a bit too low, whit the tail of the cartridge almost touching the record. When I lower the stylus on the record the cantilever go a bit down, dunno if it's normal or if it should maintein his position.. any input from dv 20x2 owner would be very appreciated on this matter.
Setting SRA on Rega?
Hi
Looking at the stylus of my dyna 20x2 with a magnifier lens today I discovered that the SRA was way off. I have 2 x 2 mm spacers under the rb700 and the arm is quite parallel to the platter if not tailed up! Is it normal that even in those theoretically fine conditions the SRA is not correct? Or is a defect of my cart? Should I put others shimmers to further raise the arm?
Looking at the stylus of my dyna 20x2 with a magnifier lens today I discovered that the SRA was way off. I have 2 x 2 mm spacers under the rb700 and the arm is quite parallel to the platter if not tailed up! Is it normal that even in those theoretically fine conditions the SRA is not correct? Or is a defect of my cart? Should I put others shimmers to further raise the arm?
- ...
- 6 posts total
- 6 posts total