Schiit Freya+ or Saga+? Vidar or Aegir?


I listen at moderate volumes in a smallish room, 15x15 with a 10’ ceiling. My single driver speakers are 95db efficient. I’m a bit confused about which amp/preamp pairing to run with. 

The Saga+ preamp has 0 gain. The Freya+ preamp has 12db in tube active mode. The Vidar amp has 100W per channel into 8ohms (which my speakers are) and 27db of gain while the Aegir has 20W per channel into 8 ohms and 22db of gain. 

I’m a bit dense as regards the necessity of gain in the preamp relative to the amp and speaker efficiency so I’m not sure which pairing suits my needs. I’ll never need all 100W of the Vidar but I wonder if that and a pre with 0 gain is a better pairing than the Freya/Aegir. 

Any input? 
larshepping

Showing 1 response by georgehifi

larshepping OP


If you have 95db efficient speaker, then probably all you need is the Class-A Aegir. If you have under 90db then the Vidar.

But if you have the money and speakers that have two sets of speaker terminals (highs/lows), then an Aegir on the highs and a Vidar on the lows.
And because they won't be the same gain a $49 Schiit Sys passive on the louder amp to equalize it down to the quieter amp.
Then a Schiit Freya as the preamp volume control for all of it.

Cheers George