Yes, bridged amps see half the impedance of the speakers! So the sound quality may suffer. And the amp may run too hot! I don't recommend doing this! Sound quality is always better driving a higher impedance! Better to run two mono amps - one per speaker. Or one channel of each amp into one speaker.
Running Benchmark AHB2 in bridged mode and 4 Ohm Speaker
Does running this amp in bridge mode mean each channel will see half the impedance i.e 2 Ohm each when connected to a 4 Ohm speaker. If so will this cause a problem when the speaker dips to 3 or 2 ohms?.
Anyone running Benchmark AHB2 in bridged mode with low impedance speakers?.
Anyone running Benchmark AHB2 in bridged mode with low impedance speakers?.