Exactly. And when that distortion is being caused by an over driven amp, it's going to be excessive heat that literally "fries" your drivers. Mechans is dead on. Unlimited power eliminates this factor from the scenario. I would definitely not use a classical cd to see how far I could go with my speakers, but buzzing due to over driven speakers versus buzzing due to an over driven amp is way less dangerous. Just turn down the volume and be reasonable.
Risk using amp Wattage than speaker rating?
I'd like to upgrade the amp for my Vandersteen 3A Sigs, but am a bit confused on whether or not I need to stay within the band of wattage (100 - 200 into 8 ohms) that is *strongly* recommended in the manual. I've read several articles/blogs/forum posts stating that exceeding the recommend power range for a loudspeaker system should be of a little concern, as long as you don't "push them too hard". What exactly does that mean? How much risk of damaging my speakers would there be if I used a 300 W/ch (into 8 ohms) amp with my speakers? I have a fairly large room, if that makes a difference. I appreciate any advice, as you all seem to be very knowledgeable about audio and have a lot of experience. Thanks, Rob
- ...
- 20 posts total
- 20 posts total