2. tech-talk
  3. 1342280455

Risk using amp Wattage than speaker rating?

I'd like to upgrade the amp for my Vandersteen 3A Sigs, but am a bit confused on whether or not I need to stay within the band of wattage (100 - 200 into 8 ohms) that is *strongly* recommended in the manual. I've read several articles/blogs/forum posts stating that exceeding the recommend power range for a loudspeaker system should be of a little concern, as long as you don't "push them too hard". What exactly does that mean? How much risk of damaging my speakers would there be if I used a 300 W/ch (into 8 ohms) amp with my speakers? I have a fairly large room, if that makes a difference. I appreciate any advice, as you all seem to be very knowledgeable about audio and have a lot of experience. Thanks, Rob
rtrauthwein

Showing 3 responses by rtrauthwein

rtrauthwein OP
4 posts
 
@Stevecham: 1) very large room. ~16'x24', it opens to the kitchen and the ceiling is vaulted and transitions from about 8' in the kitchen to 18' in the front of the room. primary listening position is ~13 ft from speakers. 2) I'm not sure about the dB level. Normally, listening levels are moderate, but occasionally I like to crank it. I am very protective of my hearing though, so if I begin to experience any discomfort, I always back it off a bit.

@Mechans, @Csontos, @Almarg, thanks for your input. This is the impression that I've gotten from my research so far, but it is always nice to be reassured some more.

-Rob
rtrauthwein OP
4 posts
 
Elizabeth... no, I wouldn't be too concerned with anything you mentioned. Sounds like you've had a few bad experiences though!

Thanks for input Molocka12
rtrauthwein OP
4 posts
 
@Rodman99999 - I'm a little confused by your response. Maybe I am misunderstanding, but you seem to be saying that you've seen a lot of damage to speakers being driven by amps rated higher than the speaker mfg's recommended wattage, but in the end you "always recommended a higher powered amp as safer, and cleaner sounding, for any given system". I guess you are saying a high power rating for an amp is good (even if above the mfg's recommended range), as long as you don't go overboard on the dB's? Is that correct?
More to discover