2. analog
  3. 139250-5876

Requirements for Moving Coil setup

I have a Bryston 2B-MC preamp (the MC being the Moving Coil designation). I currently have two turntables, each with Grado MM cartridges. I would like to use the MM cartridge (Grado Blue) on my BIC 960 as a 'preview' turntable for 2nd hand vinyl recordings. The JVC QL-A2 would then be connected to the MC input for new vinyl or pieces that have been played and are relatively clean, surface wise. What would I need in order to connect a MC to my Bryston and take full advantage of this preamps analog capabilities?
Thank you
jcipale

Showing 1 response by rauliruegas

rauliruegas
13,129 posts
 
Dear @jcipale: Perhaps a limitation for any cartridge including a MC cartridge is the tonearm internal wiring and a nchange down there is need it.

In the other side, you can get better quality level using a better Grado cartridge too, but either way the tonearm rewiring is a must to do it as the IC cable.

Regrads and enjoy the MUSIC NOT DISTORTIONS,
R.
More to discover