Replacing Turntable RCA cables

I have done it both ways with the 4002. You can use new cables and solder them directly to the internal circuit board, or you can get cables made (DIN to RCA) to connect to the existing DIN connector. If you are planning to use premade patch cables, then I suggest you get them with the DIN connector on the other end. Only if you plan to use quality cables would I suggest going directly to the circuit board.

Another thing you need to consider is if you need shielded or unshielded cables. Shielding may give less hum and noise if your turntable should require it, but shielding closes down the sound.

Thanks for the response great web sites! My 4002 has standard RCA jacks and I think it has a insulated terminal stripe that is fairly easy to get to, has anybody on this forum tried the Morrow cables?

For RCA plugs, Onix 70024 from Parts ConneXion. They have a solid copper pin. For coaxial cable, 28 or 30 gauge silver over copper with teflon insulation from Johnswireshop.com.

I use the Morrow PH 4 on my modded Sony X7 RCA's to great effect.