Replacing the binding posts at Magnepan 1,7i

I have bought Cardas CCGR-S binding posts to replace the originals at my Meggie's 1,7i

The hole at original binding posts insulator are too small.

How best to solve that out technically?

Please help I do not want to do any nonsense.

dvinkl11-08-2019 12:59pm

dvinkl OP Details Discussions Posts This discussion Message User 19 posts 11-09-2019 at 10:12am Copy Comment URL Report Comment Edit Delete bdp24, You enlarged only holes in the plates.? What about holes in the stock post insulator? Did you remove stock one and replace it with Cardas post insulator? How to remove stock post insulator not to demaged the plate?
dvinkl OP Details Discussions Posts This discussion Message User 19 posts 11-13-2019 at 08:16am Copy Comment URL Report Comment Edit Delete bdp24 Yes, they are secured to the plate with rear-mounted hex nuts also! With which tool did you remove the stock insulator? It is fix well to the rear plate. I am affraid to demage the graphic on the rear plate. Did you connect wire direct to the Cardas post with soldering or did you enlarge the original O connector too and fix it to the Cardas post?