One company that sells an aftermarket reasonably priced neutrik cable is Signal Cable. I use one with a REL Strata III and like the result compared to the factory supplied neutrik. Some other sources for the neutrik cable are Synergistic Research and on audiogon a member named Zikhmark.
REL with Integrated Amp connection Question
This is a very noobish question but then again I'm a noob with subwoofers integrated with 2 channel systems =)
Assuming I have a Krell integrated and a Yamaha HT receiver. I have two speakers, I'd like to integrate a REL subwoofer. Currently I have the Krell as my dedicated two channel amplifier connected to a DAC and transport; however I also use the Krell to power the two front speakers and use the Yamaha AVR as a processor and video switcher via Krell's HT by-pass function. Confused yet? Now I ask you how in the world can I connect a REL sub like the Q-108 into the mix? I'd REALLY hope it can be done somehow through the Krell's pre-out line level outputs and not through the speakers terminals where I would then have to run speaker wire (thick Harmonic Technology) to the Subwoofer.
Any help would be GREATLY appreciated.
Assuming I have a Krell integrated and a Yamaha HT receiver. I have two speakers, I'd like to integrate a REL subwoofer. Currently I have the Krell as my dedicated two channel amplifier connected to a DAC and transport; however I also use the Krell to power the two front speakers and use the Yamaha AVR as a processor and video switcher via Krell's HT by-pass function. Confused yet? Now I ask you how in the world can I connect a REL sub like the Q-108 into the mix? I'd REALLY hope it can be done somehow through the Krell's pre-out line level outputs and not through the speakers terminals where I would then have to run speaker wire (thick Harmonic Technology) to the Subwoofer.
Any help would be GREATLY appreciated.