2. speakers
  3. 1250719548

REL Strata III Setup - Help

I have a STRATA III and don't quite understand the directions, in particular the mode selector. I am running a 2 channel system with Dali MS5 speakers. It is not clear to me whether the mode should be LFE or Line. Or if it should be "180 DEG" or "0" as far as phase goes. Reference page 5 of the instructions where they "explain" this. Just wondering if any of you have advice in this area? Thanks for your help.
cam3366

Showing 2 responses by srwooten

srwooten's avatar
srwooten
694 posts
 
LFE is low frequency usually from a AVR sub output. Use this if you use the crossover in your AVR. Line is a full range signal from your line out. Use this if you are not using a crossover, and adjust the crossover setting on your sub to blend the best with your main speakers.

"180 DEG" or "0" as far as phase goes" Set this where the bass and PRAT are best at the listening position.

Hope this helps-
Steve
srwooten's avatar
srwooten
694 posts
 
PRAT stands for Pace, Rhythm, And Timing
More to discover