The topic of the gob of glue surrounding Namiki/Orbray cantilevers and others comes up pretty often. Clients send me “What’s that?????!!!!!” photos with disparaging remarks about retipping rather often, having no idea that the brand new cartridges are the exact same.
My take on this is that major manufacturers use this method along with half height low profile diamonds typically 0.3mm tall while a standard pass-through stylus diamond length is 0.6mm. Reasonably assume that the epoxy, which is perfectly rigid and forms an excellent bond together with a low profile diamond is lighter than a full length diamond installed/mortised into a slot or hole in a boron or gem cantilever. If the epoxy does not interfere with the contact edges of the stone, the lighter assembly is the better one.
A stronger joint is of course better for sound, but I don’t know if the glue joint is stronger or weaker than a mechanical joint. Some evidence is that it’s weaker because the glued diamonds fall out when exposed to a knock whereas the mechanical ones break the cantilever—at least with boron. With sapphire or ruby, it could go either way.
In any case, from my perspective, I think it’s an advantage if a diamond pops off leaving a cantilever intact because then all I have to do is replace the diamond like with like and go about my life. A broken cantilever is a chore to repair and exposes the naked cartridge to the risk of damage while being repaired. I’ve never damaged one yet, but replacing a diamond alone is a lot easier on the nerves.
Needlestein, aka Groovetickler