2. analog
  3. 1307847709

Question on Connecting a MC Cartridge to AQ PT-6

Hello - Would appreciate information regarding connecting a MC cartridge to AQ PT-6 arm. Do I just match the color coded prongs on the cartridge to the exact opposites on the tonearm end (which as no color coding)? Nothing in the manual online about this and my speakers seem out-of-phase.

Thanks in advance for your reply.

Marc
marc1006
4 responses Add your response
mofimadness's avatar
mofimadness
4,983 posts
 
The tonearm should also have colored wires coming out from it? You match the color of the wire to the color of the cartridge pin. If your tonearm doesn't have colored wires, you will need to find a picture that shows what color goes where on the tonearm.
mofimadness's avatar
mofimadness
4,983 posts
 
You could also use a VOM, (volt-ohm meter) to check which wire corresponds to the interconnect end.
mofimadness's avatar
mofimadness
4,983 posts
 
I looked at my PT9 arm and the wiring is as follows, looking straight into the tonearm from the front:

Top Left is White
Top Right is Red
Bottom Left is Blue
Bottom Right is Green

I don't think they changed the pinout from the PT6/7/8 to the PT9 series.
marc1006 OP
9 posts
 
Thanks Mofimadness. If the pins don't match up to your PT9 I will borrow a VOM to make certain its correct.

Regards,

Marc
Log in to respond
More to discover
80x80
Acoustic Signature Invictus Jr. Turntable
80x80
Lenco TJN
80x80
Lenco L75