PS audio m1200


Hi,

I have an ARC Ref 6 preamp with B&W 803 D3 speakers. The M1200’s have a lot of power. I am going to look for a way to demo them. The specs list 600W into 8ohm, 1200 into 4, and stable transients at 2ohms.

I believe the speaker impedance curve has a 3ohm dip. Does anyone have experience to know if these amps are stable at 3ohms with enough power?

 

Thanks

zpatenaude37

Showing 1 response by alucard19

you might to try an Anthem P2 amp, they have one listed here for $1,900.00 it will go down to 0 ohms (dead short) and keep on playing plus they do not get hot, room temp is all. This amp is built like a tank and has plenty of power for most any speaker you can get.

I've had one for over 10 years and you can run this thing at full blast all day everyday and it will just keep going, not a lot of reviews but the ones you find all say this amp is worth it and the sound is very neutral.