While this may sound over simplified - trial and error will be the best way to determine what works best.
Using all the filters in series, while it will no doubt result in a very steep cross-over slope, will most likely make integrating the sub difficult. Cross-overs effect phase and having all those filters in series can cause phase shifts which may complicate integration.
Slope and cross-over frequency depend on many things - main speaker placement, sub placement, room characteristics, main speaker and sub frequency and phase response, sub phase adjustability, amplitude (volume) etc.
I'd recommend starting with a simple slope and try a variety of locations and frequencies. Don't change too many variables at once otherwise identifying results can be difficult and misleading.
One of the best integrated subs I heard used a Rel sub with a pair of Martin Logan speakers. The speakers were set up about 1/3 out into the room and the sub was located to the right and just in front of the listening chair! The chair was located just shy of about 1/4 from the rear wall.
The sub completely filled out the entire music spectrum, not just the lower frequencies. It made the main speakers so much fuller and life like, detailed and balanced. It was if half of the speakers were turned off when the sub wasn't used! The cross over point was undetectable, the integration and acoustic results unbelievable!
So - experiment. Only change 1 variable at a time and use a variety of music you are familiar with to determine how well the sub integrates with and balances your system.
Hope this helps and best of luck, TJF.
Using all the filters in series, while it will no doubt result in a very steep cross-over slope, will most likely make integrating the sub difficult. Cross-overs effect phase and having all those filters in series can cause phase shifts which may complicate integration.
Slope and cross-over frequency depend on many things - main speaker placement, sub placement, room characteristics, main speaker and sub frequency and phase response, sub phase adjustability, amplitude (volume) etc.
I'd recommend starting with a simple slope and try a variety of locations and frequencies. Don't change too many variables at once otherwise identifying results can be difficult and misleading.
One of the best integrated subs I heard used a Rel sub with a pair of Martin Logan speakers. The speakers were set up about 1/3 out into the room and the sub was located to the right and just in front of the listening chair! The chair was located just shy of about 1/4 from the rear wall.
The sub completely filled out the entire music spectrum, not just the lower frequencies. It made the main speakers so much fuller and life like, detailed and balanced. It was if half of the speakers were turned off when the sub wasn't used! The cross over point was undetectable, the integration and acoustic results unbelievable!
So - experiment. Only change 1 variable at a time and use a variety of music you are familiar with to determine how well the sub integrates with and balances your system.
Hope this helps and best of luck, TJF.