You have to use one hand to hold the jumper, the other to hold the spade in place while you tighten the terminal. I became very adept at this from owning R1 SCs & R 2.5s. ;-)Much easier to get biwire cables though. The speakers will thank you.
Proac Response 1sc hookup
Hi,
I just received a very nice set of Response 1sc's (no manual though) and I have what is probably a dumb question. These have what I assume are the stock jumpers between the 2 sets of binding posts and these prevent me from tightening the posts enough to grip a spade lug on my single wire cables. Luckily I have another pair of cables with bananas that I can use but I was hoping someone could explain what I'm doing wrong.
Thanks,
Wes
I just received a very nice set of Response 1sc's (no manual though) and I have what is probably a dumb question. These have what I assume are the stock jumpers between the 2 sets of binding posts and these prevent me from tightening the posts enough to grip a spade lug on my single wire cables. Luckily I have another pair of cables with bananas that I can use but I was hoping someone could explain what I'm doing wrong.
Thanks,
Wes