i've also found that in-line attenuators (in my case, rothwells) had a subtle but noticeable affect on the sound, esp. at the high end. that said, i'd also be inclined to try a different passive pre. luminous audio, for example, will match your pre to the speaker efficiency, amp input impedance/sensitivity and source output voltage. i dunno what their return policy is, but they're pretty regular guys and make a good product.
Preamp Gain issues with high efficiency speakers
Hey all,
Been having a hard time with my system lately.
I recently got a pair of Zu Soul 6 that are 100db efficient. My power amp is a Conrad Johnson Premier 11 (70wpc) and my Preamp is a Conrad Johnson ET3-SE that has 25db of gain. Source is a streamer (PI2AES) with Denafrips Pontus II DAC, but it is the same regardless of source.
My issue is that even at 1 out of 100 on my preamp, the volume is still quite loud. If I were to turn it up to 30, I would be well north of 95db.
Due to a new baby, most of my listening is at low volumes.
I have been using in line attenuators but I feel like it adds a slight veil to the sound of the music.
I swapped out my Preamp for a Schit Sys passive pre and I could only turn the knob to maybe 7 or 8 pm before it was LOUD. I figured with a passive no gain pre I would be able to have more control over the volume, but this was not the case.
Is this Amp just a bad match for my speakers? I have read that it is better to have your pre running closer to 40-70% so that you are not attenuating the signal too much but I can barely get it to 5-10% before its quite loud.
Any insight, recommendations would be appreciated!