Preamp Deal of the Century

Here's another testamonial to replacing the gain pot. Yesterday, I replaced the stock Alps Blue pot with a DACT CT-2 (both 100k) in my Syrah.

I've had the Syrah since early this year. It replaced what I always condsidered a great "bang for the buck" - my Dynaco (Panor) PAS-4.

Needless to say, the Syrah is miles above the Dynaco but at 5x the price, it should be. The thing that I always noticed about the Syrah though, was a slight grain that veiled some of the music detail. I've got a pretty efficient, transparent system using a Heart CD5000 tubed CD player, Scheu Premier MKII tt, JK45 amp, and Altec Model 19 speakers.

I'm very happy to say that after installing the DACT, that grain has all but disappeared! There is much more clarity to the music. This is very noticeable. Not one of those, "If I listen hard enough, I can hear a difference" type mods.

Anyone who is/has ordered one of the Supretek products would be very wise to consider this upgrade. For those that already have one of these fine units, the replacement is very straight forward. Took me all of 30 minutes to complete.

Happy listening,

Steve

Ecclectique, you're welcome. When you say energize, do you mean break-in or warm-up? I've got a 6106 but haven't tried it yet. I know these are very rugged. Does the filament/cathode take a while to warm up? I've read the threads that state the 6106 takes a good while to break in. The 5Y3GB filament/cathode warms up as quickly as any other indirectly heated rectifier that I've used. Too early to tell if a couple hundred hours will make a difference in the sound.

While we're back on tube rolling in the Supratek pre's, I thought I'd offer a suggestion that I haven't seen yet. I believe it was the "Supretek Tubes for Everyone" post where someone talked about how much they liked the sound using a 5y3. Later, in that post and here, it was correctly mentioned that this tube should not be used since it is directly heated. There is an alternative. The Mazda 5Y3GB. Characteristics wise, this is a 5Y3. Where it differs is that it is indirectly heated. This rectifier has an ST shaped bulb and has a pretty cool filament glow to it. I've been using one in my Syrah for several weeks now with no ill effects. It's currently replacing a NOS metal based Philips GZ34 and drops the voltage to the regulators by approximately 20vdc over the GZ34. The tube is not yet fully broken in. As such, I would characterize the main difference in sound to be that the circuit does not roll off the HF as much with the 5Y3GB as with the GZ34. This is in both the line and phono stages. If you have bright system, this tube may not be for you. I had to back off the mid frequency L-pads on my Altec Model 19's due to them being overly bright after this swap. The 5Y3GB is relatively inexpensive and can be had at several different online sites. A search will quickly show these vendors.

Do this at your own risk, YMMV, and all the other usual disclaimers.

Steve

Slowhand,

I really can't say. I have little experience with 5Y3's. I primarily use or have used GZ34's, EZ81's, 5U4's, and 5R4's. This is an interesting tube, though it's too early to say whether I'll keep it in circuit or go back to the GZ34. My feeling is that this tube would sound best in a system that is on the warm side or lacking a bit in the HF area.

I think it's important to note that like any other tube rolling, the sound one hears with a tube change is so dependent on the circuit, components, room, ears, etc. that in my opinion, it's pretty darn subjective. The sounds and levels in the music that I hear may be completely different from what someone else is hearing, even in the same set up.

Steve