This is a very interesting argument for me as a recent test on my system caused me a major uncertainty about power cords gauge. I'm aware that the chosen gauge should just permit the necessary current arrival to the devices and that above a minimum value every difference due to the gauge is likely very hard to listen. I'm also aware of the problems due to a too-low power cord gauge as I have read of them everywhere.
During the last years I used industrial neoprene-jacketed power cords of approximately 13 AWG for my power amplifier (JRDG Model One) and loudspeakers (MartinLogan Aerius) as, based on my experience, I don't like the performance of hi-end power cables (except for a Cardas power cord connected to my Classe' Audio DR-5 preamplifier, possibly due to the fact that it is Cardas wired). A few weeks ago I had to slightly increase the length of the power cables of both power amplifier and loudspeakers and I decided to build 16 AWG power cords. I expected that the new performance of the system was not worse respect to the use of my previous 13 AWG power cords due to M1 and ESL panels low power. Surprisingly, the performance was largely better, with a better bass control and a less "inflated" sound as if more electrical power was "too much" for my devices. So I tested common computer power cables (of similar lenght) in black PVC of just 0.75 mm2 for both power amplifier and loudspeaker and performance has greatly increased respect to the 16 AWG cables.
It may be that my system is not highly-demanding from the electrical point of view but I really don't understand why larger-sized power cords seem to create problems.
During the last years I used industrial neoprene-jacketed power cords of approximately 13 AWG for my power amplifier (JRDG Model One) and loudspeakers (MartinLogan Aerius) as, based on my experience, I don't like the performance of hi-end power cables (except for a Cardas power cord connected to my Classe' Audio DR-5 preamplifier, possibly due to the fact that it is Cardas wired). A few weeks ago I had to slightly increase the length of the power cables of both power amplifier and loudspeakers and I decided to build 16 AWG power cords. I expected that the new performance of the system was not worse respect to the use of my previous 13 AWG power cords due to M1 and ESL panels low power. Surprisingly, the performance was largely better, with a better bass control and a less "inflated" sound as if more electrical power was "too much" for my devices. So I tested common computer power cables (of similar lenght) in black PVC of just 0.75 mm2 for both power amplifier and loudspeaker and performance has greatly increased respect to the 16 AWG cables.
It may be that my system is not highly-demanding from the electrical point of view but I really don't understand why larger-sized power cords seem to create problems.