powered sub to an Adcom speaker selector box

@cunawabi
 You can't do that. That subwoofer has line level input only. The only way to hook it up is from the preamp outputs to the inputs on the subwoofer.

Line level output from the preamp only!

If I only have one preamp output ( to my amp) on my preamp, am I outta luck for hooking this subwoofer up?

that sub-woofer only has line level in as others have noted.

IF you change to a different sub, some subs, like my Velodyne Servo 1200, have the option of speaker wire inputs or line level in. Adjustable crossover and Volume.

In your setup, the 2 pairs of 901’s always get full range signal via the selector box, and the Velodyne Sub (or similar type) would receive full frequency signal from your speaker selector, then sub use’s it’s adjustable crossover and it’s volume control for only the bass frequencies that you select on it’s crossover. It has speaker wires out, that normally/optionally go to the satellite front l/r, in your case you would not use them.

Another option would then exist: 

1. selector one: full range speaker wires to a pair of 901's
2. selector two: full range speaker wires to sub for extended bass 
3. speaker wires (after crossover, thus no low bass) from sub to other pair of 901's

selector 1, one pair full range 901's only
selector 2 sub for extended bass, other pair of 901's (now they don't try to produce low bass).

selectors 1 and 2: add the above.

@ cunawabi
You can use the subwoofer you have. You will need a pair of y adapters on the preamp. Then you can run another pair of interconnects to the subwoofer. A product like this will do the trick!
https://www.audioadvisor.com/prodinfo.asp?number=AQM22FHRD