Power Cord for PS Audio Power Plant Premier?


I recently replaced my power conditioner with a PS Audio PPP. The old unit's cable had the 20A connector, so I installed the PPP with a PS Audio Statement PC expecting some synergy. While much better than the old conditioner in terms of definition, extension, and "Hi-Fi" characteristics, with the combo there is an emphasis on upper mid/low treble that does not wear well. I tried a JPS Power AC, much richer lower mids and musical flow, but rather dark on top. The PSA cord may just have a long burn-in, but I'm curious what others might have found specifically complements the PPP - or not. Say under $1000 for the sake of argument.

Dedicated 15A AC line, but plenty of compact fluorescent bulbs and a few dimmers in the house. Current demands are low - SACD/CDP, TT, phono stage, passive pre, Bel Canto Class D 150 wpc monoblocks.
bckinch

Showing 1 response by blindjim

Just reflecting here…. I’ll assume you had none of the current stated audible irritation ‘upper mid, lower treble’ issues before installing the PPP, correct? I’ll also assume it’s well run in too, or in excess of 400 hrs.

I’m wondering too, if perhaps the PPP is the more revealing conditioner than it’s predecessor?

I’ve found in that particular range, upper mid, lower treble, is where a ground loop exhibits itself audibly. I’d at least try lifting the cable/sat ground to see if a change occurs… that’ll take 5 minutes to do, and about an hour or less listening, to reveal that truth.

Past that, again given the PPP is likely the more revelatory unit in play now, if those lighting aspects are old or not, they may bare a redo or rethinking. Flipping off their associated breakers might aid in determining if any or all of the lighting is adversely affecting things too.. more or less.

I’m considering the addition of a PPP or likewise active unit into my system as a possibility, though I’m quite fond of passive filtration currently and use Duets, UP200, and a RSA Haley now. So finding out a little more as to how the PPP works in various rigs is a good thing for me now.

I use a Elrod Sig III to supply the Haley, Voodoo Gold Dragon, & Black Dragon, or Shunyata Taipan or Python and/or a VD Power iii on the PSA units, depending upon the applications. All off 3 20A Ded ckts.

The Haley drives the power train, Duets do sources and another small HT system usually, and the UPC keeps the PC system happy.

The Elrod is a very clean, natural, and wide open sounding wire… but does need to be applied where a goodly current draw is in the works to reveal it’s true self and come to life. Your PPP should certainly provide that! Pre-owned, it’ll sure meet the $$$ requirements too.