Power cord for low-watt tube amp?

I don't care if anyone is laughing, but I am not ashamed to say that I spent more on my power cord than I did on my power amp.

But the last laugh is on me,because without the Python CX, my Decware Zen's two watts of EL84 SET power just sounds more powerful than it does with cheap power cords.

I should add that my speaker wires, Nordost Heimdall and Norse jumpers also cost more than my DecWare power amp.
So do my Ref 3A Grand Veenas, my Audio Aero Capitole cd player, my Hydra 8 and my Rega P9.
And my 3 other Shunyata power Annaconda Helix power cords each cost more than my DecWare, and so does my Manley Steelhead that drives my DecWare.

But the DecWare is the wildcard.

To give it anything less than what the other gear has would be to downgrade it's performance.
It is not the poor cousin at all in my system.
As such it is more than deserving of a quality power cord.

I've impressed a few friends and had them fooled into believing the amp was an expensive custom made unit from an old Japanese artisan with a small cult following and only a handfull are known to be in existance.

And then I tell them the truth.

It's inexpensive, and made by an American artisan with a small cult following.

If the OP has one of Steve's units, believe me, it is deserving of the best you can partner with it.

Stock power cords work, some folks like them, others try DIY, and then some prefer the more exotic varieties.

The only way to know what suits you is to try some.

In my expereince,I haven't found a product that didn't benefit from a better power cord.

So even though my amp only puts out 2 watts, it gets it's juice from a Python CX,Hydra 2,30 amp dedicated line of 6 feet from the panel.

I think the fewer the watts, all the easier to really make them sing, or screw them up.