Power amp for Audio Research SP16L pre-amp

Oops, I apologize! I'm relatively new to Agon and forgot that I should not be directing attention away from the issue that started this thread, but should instead start a new one to get responses to my question.

Stutz:

Your "diversion" is less so than most and therefore I think warrants a reply. Basically, I sold my 100.2 because my equipment is stored in a cabinet with little room for ventilation. You can see my setup by clicking on "system". The 150.2 is a digital switching amp and therefore develops very little heat (and also uses very little energy--call it "green" hifi. I really feel you give up very little sonically between the two amps. Is the 100.2 better? Yes. Is the 150.2 very close? Yep. If you have the room to breath and can afford the 100.2 that would be my recommendation. Otherwise, the 150.2 will match up very well with your preamp. Hope this helps.

Dodgealum, thanks for your response. I did find it helpful. There is sufficient ventilation for the 100.2. However, it is so hard to find these days that I might opt for something else. Good to know that you are satisfied with the 150.2. I want to replace a Rotel RB 1080. The Rotel has been a real workhorse. Never gives me any problems at all. I just believe there are better sounding amps out there. Also, the Rotel does not do well when played at low volume levels. I do want an amp that is similar to the Rotel in terms of physical footprint, weight, and having balanced inputs.