Phono Amp Spec’s

Thank you everyone for your help and recommendations!

@itsjustme 

I appreciate you trying to put some numbers on this!

To take this another step further….

Im considering the Accuphase C-47 phono amp. 
From their manual, it states the following information…

Input Sensitivity for 64dB of gain = 1.26mV for 2V output @ 50 Ohms 

Maximum Input voltage for 64dB of gain = 5.7mV

Maximum Output Level .01% THD 20-20k hz = 8.0 V

I have read that you should strive to have at least 20dB of overload margin across the frequency range. 
 

Are you able to estimate what the overload margin expressed in dB would be if my cartridge output is 1mV going into their 64dB MC input with the specifications they listed above?

Here is their link. 
https://www.accuphase.com/cat/c-47_e.pdf

Thank you so much for trying to help me better understand!

Best wishes to you all,

Don

Nice phono! Wouldn’t the maximum input voltage listed in the Accuphase lit be the point just below overload? Says 5.7mV at 64db gain. 20db above 1mV would be 10mV.

Perhaps the KAB cartridge calculator will be of help, there is also a general chart at the bottom showing the appropriate gain for a 1mV cartridge. You can also play around by changing any parameter and recalculating. Good luck.

https://www.kabusa.com/pregain.htm

To complicate things further, Bob's Devices makes a 1:5 SUT which would lift the nominal output to 5mV and allow you to go straight into the MM phono gain. Unfortunately for more money of course.

Hi Don,  Pretty busy so wont do the arithmetic but to help you along:

20dB margin = 10X margin. 

64 dB of gain is 1500X

So calculate backwards

hope the is helpful

@viridian 

Thank you so much for sharing the link 👍

However, I don’t know if I am using it correctly.

If I plug in the following data:

1mV@5cm/sec

1.2mV of Sensitivity 

64dB of gain

8 V rms Max Output 

it seems to solve for:

50dB Otimum gain (but I could use higher if I need to, right?)

46dB of overload margin

5mV before overloading

Am I doing this correctly? I would actually have 46 dB of overload margin if using my 1mV into 64dB of gain in this phono amps? If, yes then that is far higher than the 20dB that is often recommended 👍

Somehow, I feel like I’m doing something wrong  

Any thoughts?

Thanks much!

Don

@viridian 

As I relook at your previous reply, you mention that …

Overload is 5.7mV@64dB of gain

20dB above 1mV=10mV

So, does that mean I’d only have around 10dB or less of overload margin?

if yes, then that would mean I would probably clipping the phono amp quite often, right?

Im very sorry that my brain is having trouble trying to comprehend this.

Any thoughts?

I really appreciate everyone’s help 😊

Best wishes,

Don