Passive pre VS active pre


what are some of the prose and cons and what shold i be looking fore. At the moment I run my Cal. audio MK 2 through
a perpetual tec. DAC PA3 to an Aragon 24k pre. , then of to a Chord 600 Amp.. All wiring by Analisis Plus.
128x128kabir

Showing 1 response by abstract7

You need to watch the output impedance of your source equipment and input impedance of your amplifier. An active pre will take almost any source without problems, because it has a very high input impedance. Then it goes through the gain stages and output is based on the volume control. With a passive pre you only add impedance to the source signal. So if your source signal is very low (or very high impedance) you may not be able to play that source at realistic volumes.