Pass labs X350.5 jumpers and Power cables

I just picked up a Pass labs X350.5. Aside from an annoying ground loop I left left to figure out it sounds very nice.

The Pass Labs web site appears to be down. I've tried all morning to ask this question.

I want to try some single ended cables I have but read somewhere that I would need jumpers of some sort, I'm assuming, on the input side of the balanced connections. Was this amp supposed to come with jumpers?

This was a buy gone miserable. The was supposed to be nearly new, not even broken in. Upon receiving this amp I noted a lot of scuff marks, a few scratches and considerable dirt and dust. Not exactly an 9/10! I digress.

I noted substantial differences rotating power cables. Is there a general rule of power cable when it comes to this amp?

Thanks!