Is this one of those you download and print yourself? If so, how can you be sure the printed image is of the correct size? If it is off by even a bit, so too will be your alignment.
Yes! but they have two guide measurements sou you can check after printing
So ask Project.
I already did this...here's what they said:
Our cartridges are constructed so that cantilever angle corresponds to the 20 deg. record cutting angle, when the cartridge is loaded with recommended tracking force and the cartridge base is parallel with the tonearm and this again is parallel to the record surface.
Please see the 2M Red tech data here https://www.ortofon.com/ortofon-2m-red-p-317-n-1579 : recommended tracking force 1.8 g .
Please also find more information on our HiFi FAQ here https://www.ortofon.com/support/support-hifi/faq-installation .
Where and when have you bought the cartridge? If the cartridge was bought through Ortofon authorized dealer https://www.ortofon.com/where-to-buy, then you are welcome to contact them, our authorized partners have comprehensive knowledge and experience in use of Ortofon products and associated equipment and offer high standard customer service.
