2. amps-preamps
  3. 181242-145450

Okay to use RCA adapter on a fully balanced amp?

Not a XLR is better or RCA is better question BUT if I have an amp (Digital Amplifier Co) that is fully balanced and only has XLR inputs, if you use a converter and go RCA from a Preamp, are you losing out in quality?

 

Here is something from audioholics and their review of one of their amps - 

"The MEGAschino is a true fully balanced differential amplifier from input to output. It is essentially two  amps for each channel, and one amp per phase. This means it really should be used in a fully balanced system.The manufacturer supplies an XLR to RCA adapter, but these should not be used. If a balanced connection cannot be used, note that the amp cannot be driven to full power from a 2-volt single-ended output, the limit of most receivers."

blkwrxwgn

Showing 1 response by mceljo

mceljo
1,351 posts
 

A similar discussion came up on a Denafrips DAC forum. Because the Denafrips are R2R ladder DACs and fully balanced there’s four ladders to support the left (signal A and signal -A) and right (signal A and signal -A) channels. By using a single ended connection only the signal A ladders are contributing to the output being sent to the amplifier.

If you use a unbalanced RCA cable with an XLR connector on the amplifier end I would expect that the signal -A pin on each channel would not be connected. Components that are not fully balanced but do have balanced outputs use something to create the signal -A by inverting the signal. If your amplifier doesn’t have unbalanced inputs then it probably doesn’t have any mechanism to create the signal -A which would mean your amplifier would only be using half of it’s internal bits.

In your shoes, I’d absolutely work towards a balanced preamplifier.

More to discover