NHT help


I have a pair of NHT 2.5I's that I want to bi amp using 2 sa-2 amps for the woofers and b&K amp for the tops.I want to run this into my Yamaha RX-V2400.First time doing this and I wanna get it right,I have read the manuals and just dont get what I need to do.How many interconnects will I need also for this?Any help would be greatly appreciated.If someone could send me a diagram even better
thirsty93

Showing 5 responses by thirsty93

If I am runnin a sepreate subwoofer on this system is bi-amping going to result in any benifit for my 2.5's?
Right now I just have the sub connected to the the sub pre out on the yamaha and the line in jacks on the amp.I have the sub set to 0 phase and have the low pass filter at 35hz.I havent really had a chance to mess with the sub yet I just got it.
I was doin a bunch of reading last night and I need to go in and change some of my settings.The only time I use the sw-3 is for movies,when I listen to music I use a direct stereo mode that just plays the fronts.I did contact nht and they did respond,just trying to get everyone idea's here.
here is the options i have or should I say the amps i have to work with:2 sa-2 amps,I also I have a extra sa-3 amp in the box that I would have to have repaired and a sw2pi.
1.use the 2 SA-2's bi-amp the 2.5 and be done with it(if its worth it)
2.Use a single sa-3 and by amp the 2.5;s and be done with it.
3.leave the speakers alone and sell the 2 sa-2,the sa-3 and the sw2pi and be done with it.
Really need some advice here