New2Analog - Table Setup Help?


After 25+ years of CDs and such, I bought my first turntable last week. A Denon DP300F, with a built-in phono preamp. I have put it into my system, and have dome some A - B comparison, and critical listening.

Here is my problem:
I am lacking in the upper octave of all music.
No Air (Which I lust for from Vinyl).
Heavy bass and midrange
Midrange will nearly distort it is so heavy

The table is set per the factory directions, but I am not sure where to start to fix these issues.

Any suggestions?

Jeff in Detroit
jbryngelson

Showing 1 response by bob_bundus

does the arm feature a vertical tracking angle adjustment?
If VTA is incorrct (the back of the arm set too low) then the lows may be accentuated sacrificing HF performance. Start with the arm set parallel to the record, then try raising the back of the arm a few degrees at a time & listen again. Also try lowering as well. You want a VTA of about 22 degrees; you can tune this by ear. Some more expensive arms allow adjustment even while playing. The economy models not so, or may not even be adjustable atb all, in which case you might need to shim the cartrige. Lots of forum posts in the analog section in this regard, just run a search on VTA.
As Tfk advises, check the basics first.