Hmmm, that's curious -- are you sure the platter's correctly installed and seated on the bearing? I think the best advice would be to contact the US distributor, Artech in VT. Maybe they can help. My guess is that thicker spacers and longer screws could be used to raise the armboard the required amount -- then you might be able to put some thick felt pads under the corners of your dust cover to raise it just enough to clear the arm's counterweight.
Need TT setup Help
I recently purchased a Orbe Platter upgrade for my Michell Gyrodec Mk1. Prior to the upgrade the rig was set up perfectly. Ive noticed after the platter change something just isnt right. Ive noticed that the Orbe platter is 1/4in taller than the original platter. Could that be the problem here?
the Gyros have a fixed arm height based upon a dedicated armboard
thanks
the Gyros have a fixed arm height based upon a dedicated armboard
thanks