Need help in trying to trace cause of distortion


I’m trying to track down the cause of distortion which occurs in the range of about two octaves above middle C (around 1000 hz-1500 hz).  I hear it it the flute most  distinctly but it must also be there in other instruments in that range.  I’d like to determine which component is the culprit.
The equipment is fairly new except for a vintage Conrad-Johnson PV-11 preamp recently examined and Teflon recapped by the manufacturer.  I suspect it is in the GoldenEar Triton 1 speakers.
The amplifier is a Benchmark AHB2. I don’t think the other components would cause this phenomenon, so I won’t list them unless requested.  It occurs no matter what source is playing.
Otherwise the system sounds fine. Does anyone have any suspicion as to what component is causing this so I can take it for repair?
rvpiano

Showing 1 response by dekay

First thought...

-make certain that the distortion is actually coming from the speaker/speakers and not something vibrating in the room

Second thought - if it's coming from the speaker/speakers... 

-gently check the exposed screws on all the drivers for loose ones

Third thought...

-your preamp has a rapid/measured (Stereophile) increase in distortion in the 1000-2000Hz region that quickly spikes down afterwards.

The 3rd is highly unlikely, and I assume that the spike may be dependent on the tubes used when measuring the unit, but it's STILL there in the review.

I once has an intermittent "distortion" with Castle speakers, and it was emitting from the speakers.

Think I described it @ the time as a sound "accompanying" the music, but not a part of such.

The remedy ended up being the placement of small felt circles over the mounting screws of the woofer as they were dome headed screws in the sound path of the tweeter.

DeKay